warning while defining wall motion -- CFD Online Discussion Forums

May 14, 2021, 06:59

warning while defining wall motion

usamaubk

Member

Usama

Join Date: Aug 2019

Posts: 32

Rep Power: 6

Valve boundaries (1) min lift (0.000000) specified in motion file (pistondef1305.in) is inconsistent with expected geometry setup min lift (-1.000000). Please double-check.
am getting this error when I am defining user-defined BC of the piston motion
I have no valves in my geometry...am simply defining a user-defined piston BC motion instead of converge to use it wrt piston motion...the file am using is attached below.
Any suggestion apprecaited.

Attached Images

Screenshot 2021-05-14 125817.jpg (123.2 KB, 21 views)

Attached Files

pistondef1305.zip (28.2 KB, 2 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CFD by anderson, chp 10.... supersonic flow over flat plate	varunjain89	Main CFD Forum	18	May 11, 2018 07:31
[swak4Foam] installation problem with version 0.2.3	Claudio87	OpenFOAM Community Contributions	9	May 8, 2013 10:20
[blockMesh] error message with modeling a cube with a hold at the center	hsingtzu	OpenFOAM Meshing & Mesh Conversion	2	March 14, 2012 09:56
[Gmsh] discretizer - gmshToFoam	Andyjoe	OpenFOAM Meshing & Mesh Conversion	13	March 14, 2012 04:35
Cells with t below lower limit	Purushothama	Siemens	2	May 31, 2010 21:58

All times are GMT -4. The time now is 08:56.