|
[Sponsors] |
June 2, 2018, 09:57 |
Mesh Merge Information
|
#1 |
New Member
Peter Silie
Join Date: Mar 2018
Posts: 14
Rep Power: 8 |
Hello,
I tried to link a new mesh to an existing project. Afterwards I got the following Message: The mesh file (meshname) and the project (projectname) do not have the same topology. What does it mean? I click Merge Mesh definition (see attached) and the message disappears. Greetings |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 07:34 |
How to use mesh information in other source file | TurbJet | OpenFOAM | 11 | February 9, 2022 07:27 |
[ANSYS Meshing] Output Ansys WorkBench mesh information | KiiiKi | ANSYS Meshing & Geometry | 0 | September 17, 2014 10:42 |
[ICEM] Merge created block resulting in not connected mesh | imamwfgf | ANSYS Meshing & Geometry | 2 | October 20, 2013 06:22 |
about merge mesh | lian | Main CFD Forum | 3 | February 29, 2008 10:47 |