GMO suddenly can not move!

yongticle · January 31, 2018, 04:07

Hello,

I have a problem about GMO! I use the nested meshing block to simulate eight components with GMO (size: 13*0.7*3.7cm, and mass density =3000 in SI) in coupled motion and fixed x-axis rotation. However, there are two components can't move.
i am wondering if the grid size (0.77*0.61*0.8cm) can affect GMO to move?
Because those components all moved when i set the grid size (0.5*0.25*0.5cm) in first time without nested meshing block.

Thanks.

thunde47 · February 5, 2018, 13:23

Please send both the prepins:

1. without nested block
2. with nested block

January 31, 2018, 04:07	GMO suddenly can not move!	#1
yongticle New Member Shih-Hsuan Tsai Join Date: Jan 2018 Posts: 1 Rep Power: 0	Hello, I have a problem about GMO! I use the nested meshing block to simulate eight components with GMO (size: 130.73.7cm, and mass density =3000 in SI) in coupled motion and fixed x-axis rotation. However, there are two components can't move. i am wondering if the grid size (0.770.610.8cm) can affect GMO to move? Because those components all moved when i set the grid size (0.50.250.5cm) in first time without nested meshing block. Thanks. Last edited by yongticle; January 31, 2018 at 22:40.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Cannot move control points	Nat Sam	ANSYS Meshing & Geometry	3	July 11, 2016 05:35
[DesignModeler] Move selected points	oewnce932c	ANSYS Meshing & Geometry	1	June 10, 2013 02:17
Can I make a copy of a patch mesh and move it?	bigphil	OpenFOAM Programming & Development	0	October 13, 2010 10:29
Using CEL to make a 'flap' move	bramdiff	CFX	7	October 12, 2010 10:56
about GMO and STL	edward	FLOW-3D	4	March 24, 2009 11:20

February 5, 2018, 13:23		#2
thunde47 Senior Member thunde47 Join Date: Dec 2015 Location: India, USA Posts: 129 Blog Entries: 1 Rep Power: 10	Please send both the prepins: 1. without nested block 2. with nested block