|
[Sponsors] |
September 15, 2012, 06:33 |
unable to specify wall boundry condition
|
#1 |
New Member
amit sarvaiye
Join Date: Jul 2012
Posts: 4
Rep Power: 13 |
i am doing simulation of droplet on textured surface. i need to specify half wall with difft contac tangle n the other half with difft. so i made the wall as two parts in gamnit . but when i apply the boundry condition in fluent i get error dpm-bc : invalid type. please help
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how get boundry condition to air return ducts | honest | FLUENT | 1 | July 11, 2011 08:48 |
tabular boundry condition!!! | mehrdadeng | CFX | 2 | August 3, 2010 15:25 |
Wall boundary condition in cylindrical co-ordinate | shekharc | Main CFD Forum | 3 | December 2, 2009 08:20 |
Different Boundry Condition Type at the same face | cupidvenus | FLUENT | 5 | September 10, 2009 05:16 |
[Commercial meshers] ST_Malloc: out of memory.malloc_storage: unable to malloc Velocity SA, | cfdproject | OpenFOAM Meshing & Mesh Conversion | 0 | April 14, 2009 15:45 |