|December 13, 2012, 09:54||
Saving the initial condition using text command
Join Date: Aug 2009
Posts: 24Rep Power: 9
I am using Fluent 14.0, launching it from the command prompt.
How can I tell the software to store the initial condition?
I am using the following journal:
is there something that I can add?
|December 13, 2012, 11:36||
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Blog Entries: 23Rep Power: 21
file/write-date data.dat ...
if you want to save the case and the data file you can use write-case-file
New to ICEM CFD, try this document --> https://goo.gl/NEbygB
|Thread||Thread Starter||Forum||Replies||Last Post|
|Forces in OF15||richard||OpenFOAM Running, Solving & CFD||167||June 18, 2016 06:04|
|Interfoam blows on parallel run||danvica||OpenFOAM Running, Solving & CFD||16||December 22, 2012 03:09|
|Error log||vw.cfd||OpenFOAM||6||August 7, 2009 05:44|
|Negative value of k causing simulation to stop||velan||OpenFOAM Running, Solving & CFD||1||October 17, 2008 05:36|
|Could anybody help me see this error and give help||liugx212||OpenFOAM Running, Solving & CFD||3||January 4, 2006 19:07|