 |
 |
 |
|
|
|
[Sponsors] | ||||
June 5, 2013, 20:42
|
initial condition for k/omega/epsilon
|
#1 |
|
Senior Member
Ehsan
Join Date: Oct 2012
Location: Iran
Posts: 2,208
Rep Power: 28  |
hi
How can assign an initial condition for k and omega or k and epsilon in an internal flow in a tube or any other shap? Since the flow at first is stationary should values be zero?but error occurs if they set to 0.
__________________
Injustice Anywhere is a Threat for Justice Everywhere.Martin Luther King. To Be or Not To Be,Thats the Question! The Only Stupid Question Is the One that Goes Unasked. |
|
|
|
|
|
June 6, 2013, 01:50
|
|
#2 |
|
Senior Member
Join Date: Mar 2009
Location: Indiana, US
Posts: 186
Rep Power: 18 |
How are you defining your turbulence at the inlet?
Regrds Luke |
|
|
|
|
|
|
June 6, 2013, 09:52
|
|
#3 |
|
Senior Member
Ehsan
Join Date: Oct 2012
Location: Iran
Posts: 2,208
Rep Power: 28 |
hi
by these formula:  have you any comment?
__________________
Injustice Anywhere is a Threat for Justice Everywhere.Martin Luther King. To Be or Not To Be,Thats the Question! The Only Stupid Question Is the One that Goes Unasked. |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| calculation stops after few time steps | sivakumar | OpenFOAM Running, Solving & CFD | 7 | March 17, 2013 07:37 |
| SLTS+rhoPisoFoam: what is rDeltaT??? | nileshjrane | OpenFOAM Running, Solving & CFD | 4 | February 25, 2013 05:13 |
| Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 06:24 |
| Problems with simulating TurbFOAM | barath.ezhilan | OpenFOAM | 13 | July 16, 2009 06:55 |
| Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 19:07 |
Linear Mode
