|
[Sponsors] |
September 21, 2013, 08:53 |
boundary condition
|
#1 |
Member
Sa.Baraty
Join Date: Apr 2013
Location: Iran
Posts: 50
Rep Power: 13 |
Hello my friend.
I simulate one long pipe that fluid ( Gas - Methane) flow in.boundary condition are : inlet: velocity inlet constant velocity 6.85 m/s constant heat flux at ambient of pipe that is 23100 w/m2 the reference that i use for validation used the outflow boundary condition for outlet. But when i apply this boundary condition (Outflow) the software make warning that 'Maximum Temp. ex. at ****(some digit.) face'. be mentioned that flow is fully developed at exit. please help me
__________________
thanks |
|
September 21, 2013, 13:05 |
|
#2 |
Senior Member
A-A Azarafza
Join Date: Jan 2013
Posts: 226
Rep Power: 14 |
Hi
You can ignore this warning by increasing solution limit of temperature in the following address: Solve/solution controls/limits Good luck
__________________
Regard yours |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Domain Imbalance | HMR | CFX | 5 | October 10, 2016 05:57 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 07:00 |
Setting outlet Pressure boundary condition using CAFFA code | Mukund Pondkule | Main CFD Forum | 0 | March 16, 2011 03:23 |
How exactly the "pressure outlet" bdry condition compute properties on the boundary? | yating9901 | FLUENT | 3 | June 28, 2010 12:26 |