|
[Sponsors] |
March 7, 2014, 19:14 |
Falling flim over inclined plane problems
|
#1 |
Member
Join Date: Aug 2013
Location: Bangkok
Posts: 32
Rep Power: 12 |
Dear all
I try to simulate falling flim over inclined plane with 30 degree from horizontal. The domain has a width of 18 m and heigth of 1 m as reported in ansys fluid dynamics verification manual. The boundary conditions were identical with this manual. However, the results are difference. Can anyone help me to solve this. Thank in advance Regards Eakarach |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
Problems in the deployment temperature | Zero | CFX | 8 | December 23, 2013 06:35 |
Problems to sample a plane (X-Y-Plane) through the Fluid | despaired student | OpenFOAM Running, Solving & CFD | 4 | September 27, 2013 06:35 |
Problems with BCs in muliphase flow with water falling from a reservoir | Paul_l | FLUENT | 2 | March 11, 2011 04:59 |
Problems modeling subsonic engine air inlet with flow separation | TWaung | CFX | 2 | March 29, 2009 18:42 |