Display - View otions help

ryancfd7 · March 21, 2014, 05:18

Hi,
im modelling a 3 dimensional flow over a geometry, my question is whether i can view a cross section of the flow through the centreline (i.e make a sectional view at this position) of the fluid and how is this done?
Thankyou for your time.

anbu2cfd · March 21, 2014, 07:30

hi ryan,
you can use iso-surface option to view cross-section of your model, which is available in surface tab. surface----iso-surface---select mesh in the tab and specify the axis which u want to section your geom, just set some iso value and give create, once it is created check in display-----mesh. if u want to move ur sectional view try sweep surface in graphics and animation option

ryancfd7 · March 22, 2014, 06:46

It worked! Thankyou for so much for your helped

March 21, 2014, 05:18	Display - View otions help	#1
ryancfd7 New Member ryan ferry Join Date: Feb 2014 Posts: 3 Rep Power: 12	Hi, im modelling a 3 dimensional flow over a geometry, my question is whether i can view a cross section of the flow through the centreline (i.e make a sectional view at this position) of the fluid and how is this done? Thankyou for your time.

March 22, 2014, 06:46		#3
ryancfd7 New Member ryan ferry Join Date: Feb 2014 Posts: 3 Rep Power: 12	It worked! Thankyou for so much for your helped anbu2cfd likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[OpenFOAM] Color display problem to view OpenFOAM results.	Sargam05	ParaView	16	May 11, 2013 00:10
[OpenFOAM] Xlib: extension "GLX" missing on display	goldbeard	ParaView	5	March 24, 2013 13:12
How to display an isometric view in batch mode	Touré	FLUENT	1	August 18, 2012 21:10
errors when installing openfoam2.1 on ubuntu12.o4	hewei	OpenFOAM Installation	5	May 29, 2012 07:43
View / Display Zones	johnny b	FLUENT	1	April 4, 2005 05:16

March 21, 2014, 07:30		#2
anbu2cfd New Member anbu Join Date: Mar 2014 Posts: 25 Rep Power: 12	hi ryan, you can use iso-surface option to view cross-section of your model, which is available in surface tab. surface----iso-surface---select mesh in the tab and specify the axis which u want to section your geom, just set some iso value and give create, once it is created check in display-----mesh. if u want to move ur sectional view try sweep surface in graphics and animation option