 |
 |
 |
|
|
|
[Sponsors] | ||||
May 12, 2014, 12:11
|
Boundary conditions in multiphase simulation
|
#1 |
|
New Member
arrmando
Join Date: May 2014
Posts: 16
Rep Power: 13  |
Hi everyone,
I have been working on a tank which is filled with 3 fluid mixture. My problem is at the inlet boundary condition. I am only allowed to set the inlet velocity of the mixture. My problem is that the mixture has an specific fraction for each phase. But I can only select "mixture" if I try choosing a single phase, all my other Boundary conditions change to just that phase. What can I do to specify custom fractions of each phase? or separate inlet boundary conditions without having the problem with all other boundary changing to that single phase? AA |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 06:21 |
| transient simulation of a rotating rectangle | icesniffer | CFX | 1 | August 8, 2009 08:25 |
| periodic boundary conditions in multiphase model | swarnajay | FLUENT | 1 | July 24, 2009 12:04 |
| multiphase modelling, boundary conditions | Viper4573 | FLUENT | 1 | June 17, 2009 08:26 |
| Internal flow simulation boundary conditions | Kishore | FLUENT | 1 | July 10, 2007 12:42 |
Linear Mode
