|
[Sponsors] |
April 25, 2017, 16:00 |
nanofluid
|
#1 |
New Member
sinemdiscioglu
Join Date: Apr 2017
Posts: 2
Rep Power: 0 |
hello.
I'm working on nanofluid and modeled the fluent as single phase. nanofluid convective heat transfer through square cross sectional duct under constant heat flux in laminar flow. But my results are wrong.I do not know where I made mistakes.I am going to graduate depends on it and have a very very short time. Can I check my fluent files if you send them to me and Could you say my mistake. contact: sinemd11@hotmail.com +90 545 556 98 95 |
|
April 27, 2017, 18:54 |
|
#2 | |
New Member
Bennia Ayoub
Join Date: Dec 2013
Location: Algeria
Posts: 6
Rep Power: 12 |
Quote:
1-before comparing your results with experimental data, try a verification of your grid with water. 2- check your boundery conditions and select the appropriate one for your case. |
||
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Nanofluid evaporation under radiation | sab10012 | FLUENT | 0 | October 20, 2015 12:38 |
nanofluid | phenix_02 | OpenFOAM Programming & Development | 1 | September 17, 2015 04:51 |
Openfoam Nanofluid | reza2031 | OpenFOAM | 4 | March 29, 2015 18:04 |
Nanofluid Modeling at Microchannel Heat-Sink | mech-engineer | CFX | 2 | June 4, 2012 05:36 |
Simulate a nanofluid | ingenieroelder | CFX | 1 | May 10, 2012 23:46 |