|
[Sponsors] |
Set a BC based on a calculated value within a domain |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 14, 2017, 17:44 |
Set a BC based on a calculated value within a domain
|
#1 |
Senior Member
Astio Lamar
Join Date: May 2012
Location: Pipe
Posts: 186
Rep Power: 14 |
Hello all.
I want to simulate a case that volume flow through one outlet should be governed by pressure outlet. This need try and error to find the correct pressure to be set through the outlet which results in the desired volume flow. I am wondering if there is any possibility to automatize this process. For example, read the volume flow through the outlet after a couple of iterations, do the math and set a new pressure to the BC until gaining the flow that is desired? Thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to set up initial solitary wave in the domain | Ted Chu | FLUENT | 2 | September 27, 2016 02:45 |
set BC mass-flow-inlet via UDF and via GUI perform different result | sawa25 | FLUENT | 1 | February 25, 2015 00:51 |
How to set different physics timescales in two separted fluid domain? | qujianyu | CFX | 4 | December 1, 2013 04:32 |
Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 07:00 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |