|
[Sponsors] |
July 14, 2017, 15:43 |
Temperature convergence problem in DPM
|
#1 |
New Member
Petar Crnčec
Join Date: May 2017
Posts: 2
Rep Power: 0 |
Hi,
I'm trying to realize a coupled CFD-DEM simulation using EDEM and Fluent and the problem I'm facing currently is temperature convergence in fluent using discreet phase model. The temperature converges down to 1*10-5 and simply stays there. Temperatures displayed in post are completely wrong (about 100 kelvin higher or lower than expected on global scale). Inlet flow temperature is 330 K, particle temp at start is 330. Can you please give me some advice regarding this issue? Thanks! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with zeroGradient wall BC for temperature - Total temperature loss | cboss | OpenFOAM | 12 | October 1, 2018 06:36 |
Temperature Limited Problem | tuna | FLUENT | 2 | March 12, 2016 07:53 |
Convergence issue in natural convection problem | chrisf90 | FLUENT | 5 | March 5, 2016 08:30 |
CONVERGENCE PROBLEM - oil boiler | MM | FLUENT | 1 | February 15, 2007 05:24 |
convergence problem | limseokmin | FLUENT | 3 | November 14, 2004 12:43 |