|
[Sponsors] |
October 30, 2017, 10:59 |
Velocity inlet from a part of the face
|
#1 |
Member
numan
Join Date: Sep 2014
Posts: 30
Rep Power: 11 |
Hi,
I am trying to define velocity inlet just at a part of the face. So imagine that I have 2 m radius circular domain, and I want to define velocity inlet just up to 1 m radius. Is it possible in Fluent? I know I can do it in designmodeller but I wonder if I could do it directly in Fluent boundary conditions. Thank you |
|
October 30, 2017, 19:59 |
|
#2 |
Senior Member
Alexander
Join Date: Apr 2013
Posts: 2,363
Rep Power: 34 |
You may use UDF with coordinate-dependent velocity value or profile
Best regards |
|
October 31, 2017, 08:20 |
|
#3 |
Member
Jaesan Yoon
Join Date: Sep 2017
Posts: 36
Rep Power: 8 |
or divide B.C in mesh program to have two different inlet
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] crash sHM | H25E | OpenFOAM Meshing & Mesh Conversion | 11 | November 10, 2014 11:27 |
[Netgen] Import netgen mesh to OpenFOAM | hsieh | OpenFOAM Meshing & Mesh Conversion | 32 | September 13, 2011 05:50 |
ATTENTION! Reliability problems in CFX 5.7 | Joseph | CFX | 14 | April 20, 2010 15:45 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Variables Definition in CFX Solver 5.6 | R P | CFX | 2 | October 26, 2004 02:13 |