Home > Forums > Software User Forums > ANSYS > FLUENT

how to check the retained data of each design point

Mark Forums Read

Reply

Search this Thread

December 5, 2017, 03:48	how to check the retained data of each design point	#1
wonkyman New Member Fei Li Join Date: Dec 2017 Posts: 1 Rep Power: 0	Hi, i'm new for ANSYS fluent. Right now I'm using fluent 18.2 to do simulation on supersonic nozzle. I set the inlet pressure as design point and update all with the retain data being checked. How can I check the retained data like the density, pressure, etc for each DP?

Reply

Tags

design points, fluent, parameter set

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[GAMBIT] periodic faces not matching	Aadhavan	ANSYS Meshing & Geometry	6	August 31, 2013 12:25
[ANSYS Meshing] Importing Cylinders by Point Data Input with Radii	EphemeralMemory	ANSYS Meshing & Geometry	2	May 31, 2012 14:34
block-structured mesh for t-junction	Robert@cfd	ANSYS Meshing & Geometry	20	November 11, 2011 05:59
matching variable data with grid point data	anfho	OpenFOAM Programming & Development	0	May 6, 2011 16:28
Problems in compiling paraview in Suse 10.3 platform	chiven	OpenFOAM Installation	3	December 1, 2009 08:21

All times are GMT -4. The time now is 21:32.