 |
 |
 |
|
|
|
[Sponsors] | ||||
March 27, 2018, 09:26
|
How to set up from the empty condition?
|
#1 |
|
New Member
chenkangpang
Join Date: Mar 2018
Posts: 1
Rep Power: 0  |
In the beginning, the simulation is filled with pipes. How to set up from the empty condition? The mixture model is used in the oil and water two phases flow and only oil can be set up to 0 in the initialization.
|
|
|
|
|
|
March 27, 2018, 15:10
|
|
#2 |
|
Senior Member
Lucky
Join Date: Apr 2011
Location: Orlando, FL USA
Posts: 5,674
Rep Power: 66 |
You only need to specify n-1 mixture fractures because the last one is always 1 minus the rest. I.e. a mixture fraction of 0 for oil necessarily implies a mixture fraction of 1-0=1 for water.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to set the requirements for a boundray condition | qjh888 | OpenFOAM Running, Solving & CFD | 3 | May 10, 2016 20:06 |
| how to set complex boundary condition, namely a developed velocity in inlet of pipe? | milad653279 | OpenFOAM Pre-Processing | 3 | January 4, 2016 09:46 |
| How to Set Pressure Outlet Boundary Condition | freeday | Fluent UDF and Scheme Programming | 1 | August 30, 2012 11:49 |
| how to set up a wall boundary condition according to calculated wall shear stress? | gameoverli | OpenFOAM Pre-Processing | 1 | May 21, 2009 08:28 |
| What is empty boundary condition? | lakeat | OpenFOAM Running, Solving & CFD | 6 | May 7, 2009 05:16 |
Linear Mode
