|
[Sponsors] |
April 30, 2018, 22:32 |
[2-WAY FSI]: Error running coupling
|
#1 |
Member
Vish
Join Date: Dec 2016
Location: Purdue University, IN, USA.
Posts: 59
Rep Power: 13 |
Hi All
I am trying to simulate 2 way FSI using ANSYS Mechanical and FLuent. I am getting an error which is shown in the picture below: Please advise how to solve this. Regards |
|
May 2, 2018, 03:57 |
|
#2 |
Member
Leonardo
Join Date: Nov 2017
Posts: 37
Rep Power: 8 |
I am not very sure... But sometimes it doesn't like very long file paths...
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FSI problem with system coupling: Fail to couple FLUENT | sophieUNSW | FLUENT | 16 | October 1, 2020 05:20 |
Remeshing_ ANSYS 14.0_ System Coupling | acdesa | ANSYS | 4 | November 2, 2016 09:12 |
Difference between stagger/coupling iteration and coupling step | Jiricbeng | CFX | 1 | September 13, 2016 02:37 |
Coupling time duration, Coupling time steps | Jiricbeng | CFX | 0 | April 29, 2015 08:37 |
one/two way coupling of DPM | Angela | FLUENT | 3 | April 28, 2008 09:29 |