|
[Sponsors] |
October 22, 2018, 13:51 |
Error during IC geometry decomposition?
|
#1 |
New Member
Erik Myers
Join Date: Oct 2018
Posts: 8
Rep Power: 7 |
Hi All,
I've been working to learn the Fluent IC program, but have encountered some problems. I can get the geometry to compile, but there are numerous operations in the tree that say there are no faces selected for them (First Picture). The "geometry" tab of the workbench doesn't move on to the green check mark unless I delete all of these empty operations. Also, when I look at the solver setup, at the valve and piston motion graphs, they only show one value, and not a cycle. What could be causing this? Is my valve motion profile setup correctly? My engine has crossflow setup, so both valves are initially displaced a certain amount. Is that affecting anything? Thanks, Erik |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Volume Meshing Problem; YOUR GEOMETRY HAS A HOLE | mariachi | ANSYS Meshing & Geometry | 5 | May 30, 2018 02:52 |
Question about Geometry vs. Meshes | EphemeralMemory | ANSYS Meshing & Geometry | 2 | December 8, 2016 13:02 |
How to scale and translate the grid of particle data and STL geometry | Saidul | Tecplot | 1 | January 11, 2015 21:15 |
Running CFD parallel. There is no geometry file! | CrashLaker | SU2 | 6 | April 10, 2014 03:08 |
[CAD formats] translating geometry from Abaqus to OpenFOAM | skuznet | OpenFOAM Meshing & Mesh Conversion | 3 | January 10, 2014 13:49 |