 |
 |
 |
|
|
|
[Sponsors] | ||||
July 27, 2019, 00:44
|
Need Help About Post-Processing Ansys Fluent
|
#1 |
|
New Member
Muhamad Miftahul Azhar
Join Date: Jun 2019
Posts: 7
Rep Power: 6  |
Hello everyone, I got problem with ansys fluent post-processing. You can see in the picture I attached. Why the quality of temperature distribution is bad ? I mean look at near nozzle and left side of tube domain, why there isn't full blue temperature contour ? Is there something I miss ? or need some mesh improvement?. My mesh is safe based on the orthogonality and skewness (both min, max and average value)
|
|
|
|
|
|
July 30, 2019, 00:06
|
|
#2 |
|
New Member
Muhamad Miftahul Azhar
Join Date: Jun 2019
Posts: 7
Rep Power: 6 |
[SOLVED]
In the plane section, I change the offset of "X" from zero to 4 mm |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fluent in Ansys Workbench : Change Working Directory | sral | FLUENT | 4 | March 29, 2019 10:29 |
| Running UDF with Supercomputer | roi247 | FLUENT | 4 | October 15, 2015 13:41 |
| The fluent stopped and errors with "Emergency: received SIGHUP signal" | yuyuxuan | FLUENT | 0 | December 3, 2013 22:56 |
| Parallel Processing on ANSYS FLUENT 12 | srr | FLUENT | 2 | April 16, 2011 14:16 |
| Ansys Post Processing | Brian_P | Main CFD Forum | 0 | March 4, 2010 16:05 |
Linear Mode
