|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Join Date: Aug 2019
Posts: 14
Rep Power: 5 ![]() |
Hi everyone,
I am doing an iterative simulation for an optimisation problem and I have created a session file(.ces) and a state file(.cst) to automate the post-processing. What I also need to automate is to export the results of function calculator into a file. So assume I have some 20 surfaces which I want to read their Mass Flow using function calculator. How can I automate this ? thanks in advance |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFoam "Permission denied" and "command not found" problems. | iyidaniel@yahoo.co.uk | OpenFOAM Running, Solving & CFD | 11 | January 2, 2018 07:47 |
[OpenFOAM.org] Error creating ParaView-4.1.0 OpenFOAM 2.3.0 | tlcoons | OpenFOAM Installation | 13 | April 20, 2016 18:34 |
what is swap4foam ?? | AB08 | OpenFOAM | 28 | February 2, 2016 02:22 |
[swak4Foam] Problem installing swak_2.x for OpenFoam-2.4.0 | towanda | OpenFOAM Community Contributions | 6 | September 5, 2015 22:03 |
Trouble compiling utilities using source-built OpenFOAM | Artur | OpenFOAM Programming & Development | 14 | October 29, 2013 11:59 |