Mesh generation in Fluent

suna · October 13, 2021, 04:09

Hello,

An urgent suggestion is needed from the members. After mesh formation, vertical lines are coming out in inclined form and throughout the airfoil it is in inclination form in C shaped domain. In case of other people's meshing, I have seen at first the vertical mesh comes in an inclined way and then it forms as vertically from middle part of airfoil till end part of it in C shaped domain.

In my case, it is in inclined form throughout the c shaped domain. Why this happens in my case? Will there be any problem in getting accurate results? I have attached my mesh image and other peoples mesh image.

Please help everyone! Thanks!

AlexanderZ · October 13, 2021, 04:25

google "mesh skewness fluent"

suna · October 13, 2021, 05:35

Thanks for the reply. Max skewness is 0.56. I don't think skewness is the issue in this aspect!

October 13, 2021, 04:25		#2
AlexanderZ Senior Member Alexander Join Date: Apr 2013 Posts: 2,363 Rep Power: 34	google "mesh skewness fluent" __________________ best regards ****************************** press LIKE if this message was helpful

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] SnappyHexMesh/splitMeshRegion : region1 in zone "-1"	GuiMagyar	OpenFOAM Meshing & Mesh Conversion	3	August 4, 2023 12:38
[snappyHexMesh] non uniform mesh near the stl object	vava10	OpenFOAM Meshing & Mesh Conversion	0	January 31, 2021 14:41
Updating Fluent after meshing from Worbench Scripting, asks to update mesh again.	UchihaMadara	FLUENT	0	January 8, 2018 14:18
mesh generation for in-cylinder fluent simulation	hennas	ANSYS Meshing & Geometry	2	May 31, 2011 15:08
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55

October 13, 2021, 05:35		#3
suna New Member suna Join Date: Oct 2021 Posts: 6 Rep Power: 4	Thanks for the reply. Max skewness is 0.56. I don't think skewness is the issue in this aspect!