Home > Forums > Software User Forums > ANSYS > FLUENT

"DP 0" error while updating meshing

Mark Forums Read

Reply

Search this Thread

December 6, 2021, 13:20	"DP 0" error while updating meshing	#1
sailaja poudel New Member sailaja Join Date: Nov 2021 Posts: 1 Rep Power: 0	I am doing gravitational water vortex power plant simulation and I created my geometry in AutoCAD and imported to Ansys Fluent. I meshed the geometry but when I tried to update a message "((DP 0) the mesh component in fluid flow fluent requires user input before it can be updated." appears. I am stuck at this point now. what might be the problem and what is the solution for this ?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Urgent help, help pl for meshing problem	Shashi	FLUENT	8	October 8, 2008 12:24
Best Meshing scheme for Cylinder	Nutrex	Main CFD Forum	4	July 29, 2008 12:03
Meshing locks workbench window.	andy2o	CFX	0	February 1, 2008 06:01
Singularity of grid?Volume meshing vs face meshing	Ken	Main CFD Forum	0	September 4, 2003 12:09
Volume Meshing & Face Meshing? singularity of grid	ken	FLUENT	0	September 4, 2003 12:08

All times are GMT -4. The time now is 00:33.