|
[Sponsors] |
December 9, 1999, 08:31 |
regarding under relaxation factors
|
#1 |
Guest
Posts: n/a
|
sir,
is there any safe limit for specifying under relaxation factor for flow through pipe bend with 5.5 radius of curvature to radius of pipe ratio bend. The reynolds no.is 10000. the solution is not converging.... Swati |
|
December 10, 1999, 11:09 |
Re: regarding under relaxation factors
|
#2 |
Guest
Posts: n/a
|
I would recommend you to go and check your mesh quality. I have done pipe-bend simulations like this before..and convergence was never a problem.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Relaxation Factors for Transient solvers | philippose | OpenFOAM Running, Solving & CFD | 19 | March 20, 2014 04:39 |
Purpose of relaxation factors | Mohsin | FLUENT | 5 | April 30, 2010 11:57 |
relaxation factors and time accuracy | Mike | Main CFD Forum | 7 | May 21, 2005 12:41 |
Relaxation Factors | Tim | Phoenics | 3 | June 30, 2004 02:03 |
relaxation factors adjust | zhujianguo | Phoenics | 1 | July 15, 2003 11:11 |