|
[Sponsors] |
August 31, 2002, 03:00 |
swirl specification
|
#1 |
Guest
Posts: n/a
|
hi all
I am handling a duct problem with four inlets. I have to specify swirl at two inlets, with angle of +/- 10 deg. How to specify ? thanks and regards prasad laxman kane |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Howe to get swirl velocity component in 2D axisymtric swirl modeling | Perra | Fluent UDF and Scheme Programming | 2 | March 6, 2018 02:14 |
Swirl in Pressure Swirl Atomizer | varunrajendra | FLUENT | 0 | August 19, 2009 12:09 |
Quantifying Swirl | Ianto | Main CFD Forum | 0 | April 27, 2009 10:54 |
Re: swirl specification | Christian | FLUENT | 0 | September 2, 2002 08:12 |
Swirl in backflow on pressure outlets | Jonas Larsson | FLUENT | 17 | February 3, 2000 02:14 |