|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Does anybody have some idea of how to check the mesh quality for Gambit. Thanks in advance.
sxf |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
In the very lower-right corner of the Gambit GUI, there is a button named EXAMINE MESS. You may refer to the help files of the Gambit for your special case.
|
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
Thank, I already know that stuff. I wonder to know how I can judge the mesh quality with it. Thanks again
sxf |
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
sxf,you can get the geometry information about the mesh using the Quality check tool.And you can fine or coarse it with those information.
|
|
![]() |
![]() |
![]() |
#5 |
Guest
Posts: n/a
|
sxf,
Mesh skewness depends on a variety of factors: mesh type, complicated geometries, etc. Typically, you would like to keep both Equiangle and Equisize skewness below 0.75, which can be hard at times. Under no conditions should you have more than 1 or 2 cells in the 0.9 region. Usually, using the TET/Hybrid (TGRID) meshing scheme leads to high skewness (0.6-0.9) no matter what you do. Using clever decompositioning (breaking volume into more volumes for meshing purposes) to use the Cooper tool is a great way to get higher quality meshes and save on cell size. Hope this helps. Good luck. -Eric R. |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
[ICEM] trouble with mesh quality from ICEM in CFX Solver | escher25 | ANSYS Meshing & Geometry | 0 | February 28, 2011 07:38 |
[snappyHexMesh] mesh quality control and fix | tachyon_me | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2009 12:48 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |