|
[Sponsors] |
January 21, 2003, 05:05 |
what is Step AP203?
|
#1 |
Guest
Posts: n/a
|
Hello, can anyone help me? i am using proE to draw and export my drawings to gambit for meshing. but when i tried to import using gambit, it does not work. the display show: Settings-> system->"d-203-is default" ERROR:ACIS error 405:no entities were read.
it also advice to use STEP AP203. what is AP203 and how do i set it? thanks |
|
January 22, 2003, 10:08 |
Re: what is Step AP203?
|
#2 |
Guest
Posts: n/a
|
AP203 is a special type or step format which normally can be choosed during the CAD-export in th export filter. GAMBIT prefers AP203 form AP203 and AP214.
But let me tell you, that from all formats I red into GAMBIT the step-format caused the most problems. The most frequent error was the same you observed: no entities were found. Have a look to the export protocol. Normally it already will report, that no entities were exported. I dont know whether it is true for step but some geometry export formats do export volumes only! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Transient simulation not converging | skabilan | OpenFOAM Running, Solving & CFD | 14 | December 16, 2019 23:12 |
How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 15:33 |
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |
IcoFoam parallel woes | msrinath80 | OpenFOAM Running, Solving & CFD | 9 | July 22, 2007 02:58 |
Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 18:07 |