 |
 |
 |
|
|
|
[Sponsors] | ||||
January 26, 2003, 02:08
|
Boundary Definition
|
#1 |
|
Guest
Posts: n/a
|
Hi!!!
I have a cage in the shape of a cuboid. I have drawn a face(face A) inside the cage parallel to the two outer faces (face 1 and face 2) of cuboid. Some circular holes are made on this face A and substracted so that I have holes and a face B (face A-holes). I have defined one outer face(face 1) as mass flow inlet and other outer face(face 2) as pressure outlet while the other outside faces are walls. I want the fluid to flow from mass flow inlet through these holes and pass through pressure outlet. What should be the boundary type of face B and the of the holes in it. |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Implementation of boundary conditions for FVM | Tom | Main CFD Forum | 7 | August 26, 2014 06:58 |
| [Gmsh] Import problem | ARC | OpenFOAM Meshing & Mesh Conversion | 0 | February 27, 2010 11:56 |
| increasing mesh quality is leading to poor convergence | tippo | CFX | 2 | May 5, 2009 11:55 |
| Boundary conditions? | Tom | Main CFD Forum | 0 | November 5, 2002 02:54 |
| Boundary Conditions | Jan Ramboer | Main CFD Forum | 11 | August 16, 1999 09:59 |
Linear Mode
