|
[Sponsors] |
February 22, 2005, 21:29 |
Some problem about surface injection
|
#1 |
Guest
Posts: n/a
|
There are some parameters need to be specified in surface injection, but I do not really understand their meaning. Can some one help me?
Min. Diameter Max. Diameter Mean Diameter How to specify these three parameters? Just based on the experiment?? Spread parameter Number of Diameter I don't understand the meaning of these two parameters. Thanks for explanation. Jen |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Patch dependent surface mesh problem! | hadikhayyamian | ANSYS Meshing & Geometry | 14 | January 27, 2018 08:47 |
Problem Concerning free surface wave simulation | michaels | STAR-CCM+ | 3 | February 25, 2011 07:28 |
Problem with capturing water-spreading for free surface flow | devesh.baghel | OpenFOAM | 2 | December 10, 2009 01:21 |
Hollow Cone Injection Problem | JaC | FLUENT | 1 | December 3, 2009 03:03 |
Surface orentation problem in icemcfd | jeevan kumar | CFX | 0 | August 13, 2008 01:54 |