|
[Sponsors] |
March 23, 2005, 19:05 |
missing mass from dpm model
|
#1 |
Guest
Posts: n/a
|
Dear Fluent user I am calculating a 3d problem with oil combustion. I have very big problems with obtaining the specififed mass flow. I use a pressure swirl injector but I do only get at maximum 10% of the mass specified, when I calculate the sum of the volume mass source from the DPM. If I do not included droplet collision and breakup I do not have any problems, but when I initiate coll. and breakup then does the mass vanish. I have tried to do the calculation on a simplified 2d model of my problem and I could get an solution in this case.
I have tried several things, number of particles per cell, injected number of particles, increasing the temperature, adjusting number of flow iterations, under relaxation etc. Please share how you have solved this problem Thanks in advance Jan |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to put melting point data of inert particle in DPM model of Fluent | subhankar_bhandari | Fluent UDF and Scheme Programming | 1 | February 5, 2018 08:08 |
DPM mass balance help | jpinho | FLUENT | 1 | April 25, 2014 07:48 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 04:32 |
Questions on DPM model..please | panos_metal | FLUENT | 3 | October 7, 2010 07:26 |
Missing Information in SST Transition Model Formulation | Josh | CFX | 2 | September 14, 2010 12:49 |