|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
hello there,
when viewing the results of my simulation, i can't seem to be able to view the velocity magnitude contours (they appear completely blue i.e. 0 m/s). however, the velocity magnitude vectors appear to be fine? can anyone shed any light on why this is happening? very many thanks for your time. gh. |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
are you displaying the velocity contours on a wall?
|
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
try to set a specific range of values..do you know how to use the acoustic module in fluent? thanks Antonio
|
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
Hi Alec and Antonio, thanks for your reply messages. I am trying to display contours on the walls. If i try to display the velocity from the 'inlet' it only seems to diplay a tiny section of contours and then again, the rest is just blue. I am a beginner with FLUENT and so, no, i havn't yet used the acoustic module. Any help would be very much appreciated. thanks, gary.
|
|
![]() |
![]() |
![]() |
#5 |
Guest
Posts: n/a
|
Well I can say that you are assuming no slip wall conditions, so there won't be any velocity contours at the wall. You must change this in your wall boundary condition if you want to account for velocity at the wall boundary.
|
|
![]() |
![]() |
![]() |
#6 |
Guest
Posts: n/a
|
Tang, thank you very much for the tip, it seems to work fine now. Just to make sure that i did what you suggested correctly - i checked the circle for specified shear, although is it ok to leave all 3 at zero? thanks again, gary.
|
|
![]() |
![]() |
![]() |
#7 |
Guest
Posts: n/a
|
it some times does this way, specially when we stop it when it is updating the variables after a time step, i was once shocked to see zero pressure field in the domain, but after 1 iteration it recovered the pressure field.
|
|
![]() |
![]() |
![]() |
#8 |
Guest
Posts: n/a
|
I guess u r solving 2D case, hence facing this problem. Select everything in surafce panel & then plot the contour.
|
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Plotting velocity and direction contours | bhavin1986 | Main CFD Forum | 2 | April 29, 2011 16:58 |
Emergency:UDF for a time dependent parabolic velocity | zumaqiong | Fluent UDF and Scheme Programming | 12 | March 25, 2010 12:00 |
Velocity in Porous medium : HELP! HELP! HELP! | Kali Sanjay | Phoenics | 0 | November 6, 2006 06:10 |
Gradient of the velocity magnitude | anja | OpenFOAM Pre-Processing | 5 | June 6, 2006 08:39 |
Plotting ribbons with mapped velocity magnitude | Ulf | Siemens | 1 | July 30, 2004 08:00 |