|
[Sponsors] |
June 1, 2005, 05:45 |
post processing
|
#1 |
Guest
Posts: n/a
|
I am doing flow modeling in which while postprocessing i got the pressure contour . Pressure variation in the geometry is very less. So i would like to take very close range. in that i would like to get the results with 5 decimal places. Any body knows how to change the decimal places to get the result in the range as 1.12345 e+05 to 1.23456 e_05 for instance.
Regards, soundar |
|
June 1, 2005, 09:23 |
Re: post processing
|
#2 |
Guest
Posts: n/a
|
Do the following:
Display->Colormap This will open colormap window. In that, you can change the value of precesion to number of decimal points you need. You can also change the format of the number displayed in the graphics window. -US |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ansys Post processing | ano999 | ANSYS | 1 | May 27, 2011 16:24 |
NO model vs post processing in coal combustion,CFX | sakalido | CFX | 1 | April 15, 2011 14:07 |
post processing for KIVA | dirga | Main CFD Forum | 5 | April 23, 2009 10:58 |
Question about post processing | qtian | OpenFOAM Post-Processing | 0 | July 24, 2007 12:44 |
Post Processing in FEM | Abhijit Tilak | Main CFD Forum | 0 | April 26, 2004 11:59 |