|
[Sponsors] |
July 26, 2005, 13:42 |
Error on defining grid interfaces at FLUENT
|
#1 |
Guest
Posts: n/a
|
Dear all,
I'm facing a little trouble. I've already specify the interfaces boundary types at Gambit. And then, when i defined "Grid Interfaces" at FLUENT, it can't works. There's an error at the fluent window, it was written like this "Error: Poly triangulate". What is the meaning of that? And how should i do to solve that error? Thank you very much for your response. Regards Ridwan |
|
July 27, 2005, 06:41 |
Re: Error on defining grid interfaces at FLUENT
|
#2 |
Guest
Posts: n/a
|
the reason could be creating interface between a very large surface and a small surface...in that case, divide large surface into small surfaces and then use grid interface..
the reason may be surfaces are not co-planer...it happens partculary if you do in virtual operation in gambit... Dipak |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Grid Interfaces | soggy316 | FLUENT | 12 | May 17, 2012 06:17 |
B.C and Grid size LES Fluent | vishwa | Main CFD Forum | 0 | April 16, 2009 14:08 |
Grid for Fluent v.4 using Gambit? | Ray | Main CFD Forum | 3 | October 27, 1999 13:35 |
How to do Grid Generation for the FLUENT? | timea | Main CFD Forum | 2 | April 7, 1999 10:03 |
Do you have the experience about pressure oscillations at grid interfaces? | Hansong Tang | Main CFD Forum | 7 | February 22, 1999 15:48 |