|
[Sponsors] |
November 19, 2005, 23:14 |
The error message about interface
|
#1 |
Guest
Posts: n/a
|
Hi, everyone
I am a greenhand in the FLUENT, and I need your help. I will appreciate it. My model description ======================== In my model, I set two parts, one is channel and the other is diffusion layer which lies on the top of the channel. So I draw the two parts and put them together, and set the surfaces between them as the interface. Problem description ======================== After set the boundary condition, and then initiate the model. The console shows the error message WARNING: Unassigned interface zone detected for interface 6 Error: Init_Flow: unassigned interface_zones Error Object: () What's wrong with the model? What parameters need I change to correct the error? what mean's "Init_Flow"? Need I initiate the interface condition? If it is, how do I set the parameters of interface? Thank you very much! Braket |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
CFX Solver Memory Error | mike | CFX | 1 | March 19, 2008 07:22 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |