|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hello Fluent users: I have been trying to solve a case study in fluent involving moving walls but was not successful. Every time when i try to repeat the examples in the manual, i get the following error message after a few iterations.
"Negative cell volume detected" Any thoughts to overcome this would be very helpful. |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
Hi, Try to reduce your time step!
Skd |
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
What are the sutible B.C for intake air flow through engines
|
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
fuel injection directly into chamber at 40 degree BTDC. which moel is for this problem
|
|
![]() |
![]() |
![]() |
#5 |
Guest
Posts: n/a
|
What are the sutible B.C for intake air flow through engines .(open inlet valve)
|
|
![]() |
![]() |
![]() |
#6 |
Guest
Posts: n/a
|
Hi guy,
I've got exactly the same problem than you. In fact you need to input a dynamic mesh. I wonder if we don't need any grid interfaces in more, I will let you know if I succeed. |
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
deformable or moving boundaries | indd | Main CFD Forum | 2 | June 19, 2004 03:57 |
Moving boundaries | Pawel | Main CFD Forum | 7 | October 14, 2002 01:12 |
Moving Boundaries | Olga | Siemens | 0 | September 5, 2002 10:20 |
Turbulent incompressible flow & moving boundaries | Cristian Orozco | Main CFD Forum | 1 | July 5, 2002 12:45 |
Calculations with moving boundaries | Rene Francesco | Main CFD Forum | 6 | February 7, 2002 07:38 |