|
[Sponsors] |
February 22, 2007, 17:05 |
Volume adaption
|
#1 |
Guest
Posts: n/a
|
Is it possible to adapt the volume in the initial case/data file. Can I refine the grid initially?
Or, do i have to have a converged solution in order to adapt the volume? If this is the case..then how much time I should run the case before its ready for adaption? I am running a transient case. |
|
March 1, 2007, 05:37 |
Re: Volume adaption
|
#2 |
Guest
Posts: n/a
|
hi Sonia , could you explain whats the simulation all about, and why do u think of adaption even before looking at the results , i mean do u mean refinement of volume or adaption ?
Regards Pratik |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 21:14 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |