 |
 |
 |
|
|
|
[Sponsors] | ||||
November 3, 2007, 17:57
|
Tri and Quad Mesh
|
#1 |
|
Guest
Posts: n/a
|
Hi all,
I am using Dynamic Mesh and found that Tri mesh is actually better to comply with dyn. mesh parameters. However, I feel with quad mesh we can have better control of the mesh. Will the results make a different if we use tri or quad mesh? I also notice that with tri mesh we need a smaller time step than quad mesh? Could anyone pls explain. Thanks. Sham. |
|
|
||
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
| [ICEM] how can i delect the duplicate mesh line and nodes in interface between quad and tri? | snailstb | ANSYS Meshing & Geometry | 10 | September 26, 2013 08:19 |
| 3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 06:42 |
| Meshing aifoil in ICEM | student123a | ANSYS Meshing & Geometry | 13 | December 8, 2010 10:40 |
| How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 09:38 |
Threaded Mode
