|
[Sponsors] |
December 31, 2007, 05:47 |
use of Gturbo to make turbine blade
|
#1 |
Guest
Posts: n/a
|
Hi, I don't have Gturbo option in my Gambit. I have turbine blade's geometry as radial cuts at three blade heights. Which other software should i use to make a good model. Can i still make it in Gambit. Kindly guide me step by step method to make 3D turbine blade, volume, meshing etc. Any help would be highly appreciated. Many Thanks,
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mesh a twisted wind turbine blade | Laurenjiongo | Main CFD Forum | 6 | January 29, 2018 06:13 |
[Other] ANSYS CFX-Meshing problem of a wind turbine blade | Zoe | ANSYS Meshing & Geometry | 1 | July 14, 2010 02:02 |
Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 02:32 |
Regarding FoamX running Kindly help out | hariya03 | OpenFOAM Pre-Processing | 0 | April 18, 2008 04:26 |
Turbine blade section co-ordinates | Iason Hatzitheodorou | FLUENT | 1 | September 26, 2004 22:33 |