|
[Sponsors] |
February 21, 2008, 01:25 |
Meshing A Thin Volume
|
#1 |
Guest
Posts: n/a
|
Hi
I have a very thin volume that is only 0.05 units thick. Can anyone tell me a good way to mesh it well? Thanks. |
|
February 21, 2008, 17:19 |
Re: Meshing A Thin Volume
|
#2 |
Guest
Posts: n/a
|
Meshing does not depend upon volume of domain. It depends upon complexity of fluid domain. If it is simple, meshed it with hex. hex is better choice as compare to tetra.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit: Volume Meshing | fluentnoob | ANSYS Meshing & Geometry | 4 | May 20, 2009 05:21 |
Problem with meshing long, thin faces in CFX | Martin | CFX | 3 | January 8, 2009 20:51 |
On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 21:14 |
thin extrusion meshing | guillaume | FloEFD, FloWorks & FloTHERM | 1 | October 29, 2008 08:10 |
volume meshing | nikita | FLUENT | 1 | July 3, 2003 01:25 |