Error: Faceting Edge -- CFD Online Discussion Forums

October 8, 2008, 19:34	Error: Faceting Edge	#1
kartik Guest Posts: n/a	Hello! I was following the Gambit tutorial 14. Everything Went fine until meshing the face. After creating the size function. While meshing the Faces of the Airplane. I got a an error. Error: Faceting edge v_edge.730 failed for sfunction2. Check Geometry For the problem. I am using Gambit2.2.30. Can u kindly help me out with this, Thanking you Regards kartik

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Cooper meshing error: intersecting edge	Stuart	FLUENT	5	February 26, 2009 06:46
problems with single edge error in ICEM-CFD	anna	CFX	3	October 29, 2008 02:27
GAMBIT-Zero length front edge error	hari	FLUENT	0	October 22, 2007 05:39
Gambit error- the edge degenerates into a point	Jai	FLUENT	1	September 23, 2006 04:00

All times are GMT -4. The time now is 07:25.