|January 14, 2011, 10:47||
Problem with using periodic boundary conditions
Join Date: Nov 2010
Posts: 90Rep Power: 8
I am simulating one-sixth of an unbaffled mixer with a six-blade impeller. This part (one-sixth) consists of just one blade. I am using MRF for modeling of the rotation and periodic boundary conditions for the side walls.
The problem is by assigning periodic BC for these two walls, the whole vessel rotates with the same velocity and the profiles of tangential velocities in different parts of the vessel are the same, which deviate from the experimental data.
Was wondering if someone can give me some pieces of advice to handle this problem.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Periodic boundary conditions||happy5jump||FLUENT||5||January 29, 2013 17:06|
|RPM in Wind Turbine||Pankaj||CFX||9||November 23, 2009 05:05|
|3D non-conformal periodic boundary conditions||Simon Riverin||FLUENT||4||February 23, 2007 02:35|
|Problem with Boundary conditions||Mahiboobswamulu||Main CFD Forum||10||August 26, 2003 13:24|
|Problem of changing boundary conditions||fredfuyou||FLUENT||1||May 14, 2002 11:50|