|June 21, 2011, 22:27||
Streamlines impinging on wall
Join Date: Mar 2010
Posts: 32Rep Power: 9
Please take a look at the attached picture. You will see that the streamtraces (generated by TecPlot) are impinging on the wall and they disappear which is not physical. After they impinge on the wall, they should move to another direction, not disappear. It is like they pass through the wall. What do u think about that? do u think it is a computational error and should I try to change my solution? or it has a meaning that I do not know?
|August 11, 2011, 06:16||
impinging streamlines on CFD-Post
Join Date: Jul 2011
Posts: 1Rep Power: 0
i'm facing the same issues on CFD-Post. I recently upgraded to ANSYS 13.0 and I start to have discontinuous streamlines that stops on the solid faces. Whatīs the problem? If I open a run done on ANSYS 12.1 itīs ok.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Natural convection in a closed domain STILL NEEDING help!||Yr0gErG||FLUENT||3||June 12, 2013 02:12|
|Water subcooled boiling||Attesz||CFX||7||January 5, 2013 04:32|
|Fluent3DMeshToFoam||simvun||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||48||May 14, 2012 05:20|
|Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug||unoder||OpenFOAM Installation||11||January 30, 2008 21:30|
|Multicomponent fluid||Andrea||CFX||2||October 11, 2004 05:12|