 |
 |
 |
|
|
|
[Sponsors] | ||||
March 16, 2012, 21:03
|
Nonpremixed flame using Laminar Finite-Rate
|
#1 |
|
New Member
Samuel
Join Date: Nov 2011
Posts: 12
Rep Power: 14  |
Hi,
Recently, I am working on non-premixed combustion in porous media. However, compared with the experimental results, the flame seems too short and the combustion process is quite stiff. Because of getting divergent results in former cases, I use Stiff Chemistry and Coupled solver to take a special care of this laminar finite rate model. I doubt if it is the Stiff Chemistry Solver that causes the problem. Is there someone who once had the same problem? 
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Laminar Finite Rate Chemistry - Pre-exponential | Arun | FLUENT | 7 | August 30, 2012 07:09 |
| Laminar finite rate combustion model | Shankar | FLUENT | 3 | June 24, 2004 15:40 |
| Pre-mixed combustion- Laminar finite rate model | Shankar | FLUENT | 8 | March 31, 2004 05:18 |
| Premixed combustion -Laminar finite rate model | Shankar | FLUENT | 4 | March 17, 2004 15:32 |
| Laminar Flame with CFX5.6 | matej forman | CFX | 2 | October 13, 2003 01:56 |
Linear Mode
