Reliablity of SOLIDWORKS FLOW SIMULATION...

addy01 · March 6, 2013, 09:28

i m doing my research project on d topic aerodynamic improvement in heavy vehicle and effect of fuel consumption at undergraduate level. i m using solidworks flow simulation...and Autodesk CFD. can these software provide me reliable result?? what is the relaiblity of these softwares??
PLS REPLY...

Thnx & Regards.
ADITYA

plucas · March 6, 2013, 12:12

I have used solidworks flow simulation, but I cannot comment on its accuracy. It seems like it was designed just to be vary easy to use but lacks a lot. I personally would not use it if I was relying on quality results. I have never used autodesk cfd.

March 6, 2013, 09:28	Reliablity of SOLIDWORKS FLOW SIMULATION...	#1
addy01 New Member adi Join Date: Feb 2013 Posts: 13 Rep Power: 13	i m doing my research project on d topic aerodynamic improvement in heavy vehicle and effect of fuel consumption at undergraduate level. i m using solidworks flow simulation...and Autodesk CFD. can these software provide me reliable result?? what is the relaiblity of these softwares?? PLS REPLY... Thnx & Regards. ADITYA

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Is Solidworks Flow Simulation Good?	corriolisforce	Main CFD Forum	4	October 22, 2018 11:44
About Some Concepts:Laminar flow, turbulent flow, steady flow and time-dependent flow	Jing	Main CFD Forum	8	October 5, 2018 17:02
Comparison between Solidworks Flow Simulation and Ansys Fluent	Bruce828	Main CFD Forum	5	February 23, 2013 10:13
Blockage in pipe ( using solidwork flow simulation)	jchow	FloEFD, FloWorks & FloTHERM	1	January 16, 2012 16:03
SolidWorks Flow Simulation	Koranten	Main CFD Forum	5	October 29, 2010 11:24

March 6, 2013, 12:12		#2
plucas Senior Member Anonymous Join Date: Dec 2011 Location: USA Posts: 108 Rep Power: 14	I have used solidworks flow simulation, but I cannot comment on its accuracy. It seems like it was designed just to be vary easy to use but lacks a lot. I personally would not use it if I was relying on quality results. I have never used autodesk cfd.