How to simulate a pipe flow with a recirculating loop? -- CFD Online Discussion Forums

June 25, 2014, 07:40

How to simulate a pipe flow with a recirculating loop?

Jing

New Member

Jing Shi

Join Date: Feb 2013

Posts: 20

Rep Power: 13

Hi everyone,

Could anyone give me some instruction on simulation of a pipe flow (the main flow) with a recirculating loop (secondary flow)?

The physical problem is described in the attached figure. The oil-water mixture flows from the left to the right hand. It is sucked by a pump (at a given rate downstream) and is re-injected to the front through a number of small jets.

To me, there are two inlets and outlets. Is it possible to simulate this process using FLUENT?

Any instructions are appreciated!

Regards,

Jing

Attached Images

Mixing.jpg (48.6 KB, 18 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Why Differences between tetrahedra polyhedra and prism mesh pipe flow computation with sonicLiquidFoam	chnrdu	OpenFOAM Running, Solving & CFD	5	May 7, 2018 03:23
Pipe flow heat transfer	feedq	FLUENT	10	November 26, 2014 08:23
sonicFoam - pressure driven pipe: flow continuity violation and waveTransmissive BC	Endel	OpenFOAM Running, Solving & CFD	3	September 11, 2014 16:29
Steady pipe flow mean velocity higher than inlet velocity	anita	OpenFOAM Running, Solving & CFD	7	September 25, 2012 05:35
Hydrostatic pressure in 2-phase flow modeling (CFX4.2)	HB &DS	CFX	0	January 9, 2000 13:19

All times are GMT -4. The time now is 06:18.