 |
 |
 |
|
|
|
[Sponsors] | ||||
October 19, 2007, 10:38
|
modeling cooling holes in turbine blades
|
#1 |
|
Guest
Posts: n/a
|
hii all,
i'm doing a project in simulation of film cooling of turbine vanes. kindly someone tell me how to model the same in gambit. i have hole geometry in my hand. |
|
|
||
|
September 9, 2010, 12:13
|
|
#2 |
|
Member
pedro gonzalez
Join Date: Aug 2010
Location: Barcelona, Venezuela
Posts: 35
Rep Power: 15  |
how do you do?. Can help me to draw gas turbine cooled blades in the software ANSYS 12.0 CFX, in the Bladedesign or BladeGen, in WORKBENCH, I am trying to simulate in ANSYS CFX 12.0 with gas turbine blades with film cooling and impingement cooling. do you have any handbook or manual of Bladedesign or BladeGen 12.0 ?. I appreciate any response. I am student in mechanichal engineering. Greetingsˇˇˇ
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CFD analysis on wind turbine rotor | Ken (Wind Turbine CFD Super Rookie) | Main CFD Forum | 45 | February 9, 2016 14:07 |
| [Other] Design gas turbine blades with film cooling and cooling Impingement in Ansys 12.0 | pedrin84 | ANSYS Meshing & Geometry | 7 | February 2, 2013 11:52 |
| Design gas turbine blades with film cooling and cooling Impingement in Ansys 12.0 | pedrin84 | CFX | 3 | August 25, 2010 14:07 |
| Design gas turbine blades with film cooling and cooling Impingement in Ansys 12.0 | pedrin84 | ANSYS Meshing & Geometry | 0 | August 25, 2010 12:19 |
| modeling of turbine blades | Usman | FLUENT | 0 | January 20, 2008 06:00 |
Linear Mode
