|
[Sponsors] | |||||
|
|
|
#1 |
|
Guest
Posts: n/a
|
Hi everyone,
just a quick question. Take a look at figure 3 in this paper http://www.doiserbia.nbs.bg.ac.yu/im...360704157T.pdf and tell me if the results are grid independent. Tell me if I am going mad. Also check out those global performance characteristics on pp.161. |
|
|
||
|
|
|
#2 |
|
Guest
Posts: n/a
|
Hi
In my view, I would say that fig 3a shows that the efficiency prediction for the 450,000 and 400,000 cell run show very close similarity, 3b and 3c do not. At the higher cell count the predictions are significantly different from the lower cell count. In a grid independent solution the predicted values should be the same for each grid. This is not the case in figs 3b and 3c. Have a beer, relax..you're not going mad. regards allan |
|
|
||
|
|
|
#3 |
|
Guest
Posts: n/a
|
I tend to agree. As a result, I would be suspicious of the results in 3b and 3c. Strange.
Many thanks for the reply. |
|
|
||
|
|
|
#4 |
|
Guest
Posts: n/a
|
no problem
hope you enjoyed the beer! allan |
|
|
||
![]() |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| grid independence questions | lucifer | FLUENT | 0 | December 14, 2009 20:59 |
| unstructured mesh grid independence for Fluent | Shane Schouten | FLUENT | 0 | October 11, 2006 17:50 |
| Grid independence check | Mattis Voss | FLUENT | 1 | November 23, 2005 11:30 |
| Grid Independence problem for simple pipe geometry | chanchala | FLUENT | 13 | November 20, 2003 09:24 |
| Combustion Convergence problems | Art Stretton | Phoenics | 5 | April 2, 2002 06:59 |