|
[Sponsors] |
December 16, 2020, 01:46 |
How to create a new forum/subforum?
|
#1 |
New Member
Alexis Espinosa
Join Date: Aug 2009
Location: Australia
Posts: 20
Rep Power: 16 |
Hello,
As staff from an HPC centre, we are exploring the possibility to start a forum for our CFD users here. Could someone explain me the steps/requirements for creating forums in this platform? I have already sent a message through the "contact form", but have not received an answer yet. Thanks a lot, Alexis Espinosa |
|
December 16, 2020, 02:52 |
|
#2 |
Super Moderator
Alex
Join Date: Jun 2012
Location: Germany
Posts: 3,399
Rep Power: 46 |
This is the right place to start a discussion about a new sub-forum.
https://www.cfd-online.com/Forums/si...k-discussions/ But you will have to be more specific when pitching your idea there. As it stands now -sub-forum for the users of your HPC facility- I don't see how that could fit in. The scope of the proposal appears both too narrow (only users of your HPC facility) and lack focus (I'm sure that you run a whole zoo of different applications on your machines). Sorry, but that's just my brutally honest opinion. You might want to look into alternatives. |
|
December 16, 2020, 04:29 |
|
#3 |
Senior Member
Sayan Bhattacharjee
Join Date: Mar 2020
Posts: 495
Rep Power: 8 |
Hello Alexis, Would your forum be private to only your group? I have been lurking here for six years as a normal user, but don't know if there's any private forum available for a certain lab/department. Most of the forums, as we can see, are focused on a certain topic of interest--Electromagnetics, Structural Simulations, or around certain CFD software--ANSYS, CONVERGE, etc. I didn't see a forum only for a certain lab/department. Also, based on the privacy and confidentiality requirements of your department, you might need a private forum to protect your Intellectual Property. In such cases, it would be better to opt for a service that allows you to protect your IP. Have a nice day |
|
January 20, 2021, 23:56 |
Thanks
|
#4 |
New Member
Alexis Espinosa
Join Date: Aug 2009
Location: Australia
Posts: 20
Rep Power: 16 |
Thanks a lot for the feedback.
You are both right, the final deployment of a subforum related to our HPC centre may have some inconveniences. We are still exploring our possibilities. Many thanks, Alexis |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
create the file *.foam | phongstar | OpenFOAM | 12 | October 14, 2018 18:06 |
[GAMBIT] How to plot S pipe | mariam.sara | ANSYS Meshing & Geometry | 36 | November 7, 2013 15:22 |
[ANSYS Meshing] is it possible to create virtual edges on the blades | er_ijaz | ANSYS Meshing & Geometry | 0 | November 3, 2013 05:15 |
[DesignModeler] Design Modeller create surface | papis | ANSYS Meshing & Geometry | 0 | October 31, 2013 13:52 |
About create interface! | xinzhiyu2008 | STAR-CCM+ | 2 | August 6, 2010 20:47 |