Home > Forums > General Forums > Main CFD Forum

Hard Edges and Sweep Meshing

Mark Forums Read

Reply

Search this Thread

February 7, 2022, 15:06	Hard Edges and Sweep Meshing	#1
Bdew8556 Senior Member Brett Join Date: May 2013 Posts: 205 Rep Power: 12	Hi guys, I'm having trouble sweep meshing some geometry. It says there are hard edges. Basic question I'm sure, but what is a hard edge???

Reply

Tags

design modeller, hard edges, meshing 2d, sweep mesh

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] (Sweep + Inflation) Corner Mesh Quality	Luiz	ANSYS Meshing & Geometry	0	September 7, 2018 15:59
[ANSYS Meshing] Meshing 2D rectangles.	cfd_worker99	ANSYS Meshing & Geometry	1	October 3, 2017 12:55
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing	David-CFD	ANSYS Meshing & Geometry	1	April 1, 2011 05:22
[ICEM] Icem 12.1, O-grid - sweep combination	pertupd	ANSYS Meshing & Geometry	1	June 18, 2010 14:00
Sweep Real Faces, Time Problem !!!	Thomas Farmakis & George Zioupos	FLUENT	0	June 8, 2001 07:54

All times are GMT -4. The time now is 14:11.