|
[Sponsors] |
Regarding the simulation of thermal wheel heat recovery system |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 25, 2024, 09:30 |
Regarding the simulation of thermal wheel heat recovery system
|
#1 |
New Member
Amanpreet Singh
Join Date: Feb 2023
Posts: 4
Rep Power: 3 |
Hello everyone,
I am working on a thermal wheel heat recovery system. I modeled the wheel as a cylinder with 70% porosity and the rotational speed of the wheel is 120rpm and modeled the wind tunnel and sample room as one body and thermal wheel in between that. Is it possible that air passes through the thermal wheel and further goes to the sample room because the wheel is placed between them? how to model that and how to set the setup. Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
reverse flow in centrifugal fan blades | kalm | CFX | 20 | December 2, 2023 06:25 |
Noise Prediction in Heat Recovery Steam Generator System | Kamal Kosta | Main CFD Forum | 0 | October 3, 2023 00:22 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
Info: Short Course On Thermal Design of Electronic Equipment | Arnold Free | Main CFD Forum | 0 | August 10, 1999 10:18 |