|
[Sponsors] |
October 27, 2001, 01:35 |
SOLAVOF Sample Test Problem
|
#1 |
Guest
Posts: n/a
|
I am rewriting the original SOLAVOF Fortran program in C++, but encouter a problem. I try to simulate the same sample test problem in the report (undular bore calculation) in page 44. All parameters are the same (NMAT=1).
QUESTION 1: At t=0 (page 46), why U[1][7] = 0.2? Since F[1][7] is 0, why U is set for an _empty_ cell at t=0? The SETUP routine initialize U [i][j] only when F[I][J] > 0, so it's unlikely U[1][7] is set by SETUP. I've checked BC subroutine too, but it does not set U[1][7] either. QUESTION 2: The input FLHT (horizontal free surface height) is 1.0f, and del_y of mesh is 0.2, the fluid should occupy the bottom five rows: I=2~6. At t=0 (page 46), before anything started, why F[1][6] is not 1 but 9.99999E-01? BIBLIOGRAPHY: B. D. Nichols, C. W. Hirt, and R. S. Hotchkiss, SOLA-VOF: A Solution Algorithm for Transient Fluid Flow with Multiple Free Boundaries, LANL report LA-8355, 1980. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sample utility problem | And | OpenFOAM Post-Processing | 36 | May 20, 2014 09:50 |
A new test harness for OpenFOAM | mbeaudoin | OpenFOAM Announcements from Other Sources | 0 | June 17, 2010 11:36 |
Sample utility not working properly | titio | OpenFOAM | 2 | June 9, 2010 11:45 |
Velocity profiles problem behind the elbow (3D problem) | kabat73 | FLUENT | 8 | May 9, 2010 05:26 |
setup vof test problem | Fang Jin | FLUENT | 1 | June 14, 2005 09:27 |